User Tools

Site Tools


openwrt:reflash_with_usb

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
openwrt:reflash_with_usb [2013/11/01 17:22]
matthias reformatting
openwrt:reflash_with_usb [2014/05/30 09:28] (current)
matthias
Line 1: Line 1:
-====== Reflash using an USB Stick ====== +[[http://piratebox.cc/openwrt:reflash_with_usb]]
-The following howto works, if you already have usb drivers (pre) installed. This can be manually or within a custom image +
- +
- +
-  * Download Image (link) FIXME  to your computer +
-  * Power off the MR3020 +
-  * Take your USB device and put the downloaded file to your usb device +
-  * Connect the MR3020 to your computer via Ethernet. +
-  * Set up your of the computer to 192.168.1.2 +
-  * Start to ping 192.168.1.1 (this is the failsave IP) infinitive +
-  * Power the MR3020 on and when the WPS Button starts to blink , push it (it will blink faster) +
-  * You see the ping getting response +
-  * Run  +
- +
-    telnet 192.168.1.1 +
- +
-  * Plugin your USB Device to the pbx-router +
-  * Do the following commands: +
- +
-   /etc/init.d/boot start  (This will return some error messages - ignore it) +
- +
- +
-  * Try +
- +
-  mount /dev/sda1 /mnt +
-  cd /mnt/ +
-  mtd -r write <your filename>​ firmware +
-   +
-  * The device reboots automatically after successfully flashing +
- +
- +
-If mount does not work, you can do +
- +
-  mount_root +
- +
-Wich mounts your root partition and you can edit files. after you are finished run +
- +
-  reboot -f +
- +
-Source (http://​wiki.openwrt.org/​doc/​howto/​generic.failsafe) +
openwrt/reflash_with_usb.txt · Last modified: 2014/05/30 09:28 by matthias